Yep! I got mine on Friday and installed them on Saturday. Remove the old brake and clutch pedal cover and the new ones fit right on. The new throttle cover fits over the old one with the long thin bolt going through the rolled pin hole. It's a major pain to get through but persevere. I haven't got around to looking at the dead pedel yet, I think it's going to need self tappers as the existing dead pedel is fixed with only two screws top and bottom middle. The new pedals make 'heel and toe' WAY easier. Good luck!

 

Will do. It's either a job for tomorrow or next weekend. If you like them on the RS, you're going to LOVE them on the STi.

 

I got mine from http://www.isrperformance.com/main.html They can also do custom STi floor mats! My wife bought me some and they are VERY good!

 

they look sweet, but I personally wouldn;t have them fitted as there are already enough STi logos in the rest of the cabin

 

You really can't even see them unless you're looking all the way down. I put them in as I found the OEM pedals weren't close enough together (for me) to heel and toe. I didn't want to get Razo or Momo etc. and these looked good. I figured they should fit better than a generic set too.

 

I think the stock STi pedals heel & toe rather easily. If you want a dead pedal to match the Stock STi pedal try the Auto Speed made pedal from j-spec tuning. Installs in a minute and looks great.

 

You must have big feet! Just kidding, I needed the throttle a little closer. These are the pedals in my STi.

 

Thanks! Bit of a problem with the dead pedal though. The length of it is actually shorter than the one currently fitted. When the old one is removed it leaves two big holes in the carpet and the sheet metal. The new pedal is not long enough to cover them so I'll probably just leave the old one in place unless I can come up with something clever (unlikley :-( ).

 

I got the same thing from ebay.