when is it too much?
Thread Starter
Registered User
Joined: Feb 2003
Posts: 361
From: ghettos of malibu, yo
when is it too much?
I have kinda a noob question:
I am planning on harwiring a ps2 to my TSX, and was going to use an ACC lead from the factory amp (just a little guy). I am also running a sync stripping IC that requires 12V power. Lastly, I need to wire a switch to 12V to control a 4pdt relay to switch between the Navigation and playstation RGB video sources. The draw from the ps2 is pretty low, about 3 amps I think, and everything esle is much lower also. Will the amp's power and accessory leads be enough for what I am planning on doing?? What wire guages would you suggest for everything?
I am planning on harwiring a ps2 to my TSX, and was going to use an ACC lead from the factory amp (just a little guy). I am also running a sync stripping IC that requires 12V power. Lastly, I need to wire a switch to 12V to control a 4pdt relay to switch between the Navigation and playstation RGB video sources. The draw from the ps2 is pretty low, about 3 amps I think, and everything esle is much lower also. Will the amp's power and accessory leads be enough for what I am planning on doing?? What wire guages would you suggest for everything?
Thread
Thread Starter
Forum
Replies
Last Post
gruppe-s
Exterior / Interior Lighting
1
Feb 16, 2006 06:44 PM
skimobile
Aftermarket Forced Induction - Turboed factory NA engines
1
Jul 28, 2005 07:14 PM
SubySal
Suspension, Handling, and Brakes
5
Jul 2, 2004 04:13 PM