https://www.i-club.com/forums/forumd...?s=&forumid=70

 

All the wires needed for setup are there, and there is a wire for the antenna that goes to the rear window.

 

everything is wired just remember when you hook up the radio the antana has to be powered up with the power antana wire from the radio

 

whoes yo daddy?
i havea linky:
http://forums.nasioc.com/forums/show...hreadid=464212

-dashiet

 

Thanks for the link

 

does this mean all I need is an antenna or just the wire?
Every shop is giving me the run-a-round about the antenna. If so, can I do this myself?

 

the antenna is built into the rear glass. there is an signal amplifier attached to it in the drivers side rear panel above the shoulder harness .

it is all connected into the factory audio wiring harness located behind the radio delete plate.

if you use univeral wiring harnesses (circuit city sells them) to plug in your radio/cd headunit , the antenna amplifier will be powered up automatically.
if you have to splice your wires , then you need to do what ds baruuuuu advises.

in addition the standard coaxial cable for the antenna is also located behind the delete plate and needs tbe plugged into your radio/cd/headunit .


and even though the factory wiring is in for the audio system,
the adaptors to attach the tweeters and anchors for attaching speaker screws to the door were not installed at the factory.
lots of installs have been painlessly and successfully done using
adaptors from http://www.iaperformance.com/ and the site has
instructions with pictures on door panel removal and speaker installation .

 

liky linky too, but hairy handy??:banana: :banana:

 

Moved thread to appropriate forum.

--
0==WW==0
"…axles of evil…" - george w. bush