Looking for sheetmetal to make a front splitter/mess around welding and cutting if you have any in those sizes please let me know! Donations are always welcomed too

 

Large street signs work well. Just make sure you obtain them legally.

 

true but large street signs are very hard to obtain "legally" and they're pretty heavy and thick... not a good combo for a front splitter

 

how much you looking to spend?

-Ryan

 

i work for a steel fab company and we buy from a company in Vacaville.

hit up Valley Iron and see if they will sell to you,
797 Elmira Road Vacaville, CA 95687
(707) 359-2600

 

Thanks guys!

 

Are you looking for the sheet metal to be the actual splitter piece? If so I would advise against this as you'll need something extremely heavy to stop it flapping in the breeze. Personally I would hit up somewhere like Midwest sign and get some allumilite sign board and make an aluminum frame instead.

 

I was going to use two pieces of sheet metal and sandwich a metal tube frame in the middle it should've pretty sturdy

 

Sounds heavy too!

 

Not if it's aluminum framing that's why I wanted sheet metal it's thin and light much lighted than a stop sign lol

 

Yea it is but I still suggest Allumilite for a front splitter, it's basically the poor mans carbon!

 

Where can I obtain this allumilite?

 

I have a full sheet that I'll sell to you. It's like 7X4 or close to that. I also agree with the rest about fabing bracing for it

 

Most sign board companies sell it but I know for sure Midwest Sign in Hayward carry it in 8'x4'