This mani will swap in to an 02-05 WRX. I used Krylon's "Wrinkle Finish" black on everything and did a final cure on the paint with a high temp heat gun (400+ F).

Intake manifold has been ported and polished also. All gasket mating surfaces polished.

PM me with any questions on the setup. Thanks!

Intake manifold - $180 shipped/$160 picked up

 

I like the black look... if someone were to send you a wrinkle red APS CAI, turbo inlet tube and STi intake manifold, could you do the same paint/cure process? Also, could you do it to an intercooler?

 

Yep, shouldnt be a problem with the inlet and intake mani.

I'd rather not do it to an intercooler bc this paint may get in the way of heat transfering off those small fins of the IC.

 

how much would you charge to do an exhaust manifold with the same paint?

 

I don't know about this paint and exhaust manifolds. I'd look in to thermal coating for those parts.

 

bump

 

bump. I can do this as a service also for other years/models.

 

bumpage

 

Wow looks good!

better job on paint than the factory does on the red

 

super clean looking!

 

Thanks! It took me a few days just to paint/cure/paint/cure ect.

Ya I compared it to an 07 STI manifold I had here. It's the same exactly wrinkle look, but black and properly prep'd/coated/polished. O, and it's evenly painted ALL around. haha

 

Danke!

 

bumpppp

 

Rockin out to norcal musik... Deftones bump.

 

hey woodward...

would you be able to do this in different colors? if i were to supply the paint needed according to your specifications?