Ok so while doing a pretty large shop clean up yesterday we came across the following parts..



Used WRX ACT Streetlite flywheel $100

2 x Used STI ACT Streetlite flywheels $125 each

Used K&N carb legal WRX/STI intake and shield $75



STI red intake manifold (needs cleaning ) $50



STI larger TMIC shroud $50




Catless uppipe welded to port matched header, this was actually off of Gary Sheehans USTCC WRX $50

Beefy rear diff protector $50

 

Also there are two skids of stuff that we're junking with all sorts of randomness on them that anyone is welcome to take whatever they want from (better do it today before the scrappers roll through tomorrow morning!)

 

Someone should get on that Cobb SS. I have one and love it

 

Do any of those flywheels and stainless steel lines work for an 07 wrx?

 

Oh I also found 3 stock BOV's if anyone needs one $25 a piece sounds reasonable..

For people going back to stock I counted at least 2 stock intake setups in the pile being tossed so if you need one come by and grab one

Mike

 

The stainless goodridge brake lines will work, the flywheels wont though.

The stainless brakelines can be had for $40

Mike

 

you wouldn't happen to have ac lines for 05 wrx/sti that runs behind intercooler would you?

 

how hard is it to install a short throw?

 

Less than 30-min
Just make sure you have a rubber mallet and a wood block

 

It's one bolt. Very easy. Look up a writeup.

 

Actually I think I do, let me check for you.

Mike

 

would that short throw fit in an 05 legacy gt? if so i would like it asap haha

 

I would love you if you do! it's the low pressure one i think. with the cap really close to the turbo.

 

I am assuming you need the top one in this picture?

 

Yup it will fit a LGT with a 5 speed.