FS: RCE Non-Lowering Front Camber Plates 02-07
Thread Starter
Registered User
iTrader: (11)
Joined: Mar 2006
Posts: 1,075
From: San Francisco
Car Info: 05 WRB STi
FS: RCE Non-Lowering Front Camber Plates 02-07
I picked these up used and planned to install them on my new Tarmac2's, but I wasn't happy with the condition. They are still useable, I just opted for a new set of Vorshlags.
They come with a top nut, but I'm not sure what the exact thread/pitch is. You could also just get a plug for the top and use the nut that comes with what ever strut you are running.
-- $200
They come with a top nut, but I'm not sure what the exact thread/pitch is. You could also just get a plug for the top and use the nut that comes with what ever strut you are running.
-- $200
Last edited by Ipecac; Dec 21, 2013 at 10:39 AM.
Thread Starter
Registered User
iTrader: (11)
Joined: Mar 2006
Posts: 1,075
From: San Francisco
Car Info: 05 WRB STi
There is nothing structurally wrong with them. They are just all banged up, as you can see from the pictures. It's hard to tell, but the washers are also bent a little from being torqued down too hard. Luckily, that's a cheap fix.
It might also be good to run a thread tap through the top nuts, but I don't know the exact thread size.
That's part of the reason I listed them $50 less than I paid. I figure that's about what it would cost in time/parts to clean them up.
It might also be good to run a thread tap through the top nuts, but I don't know the exact thread size.
That's part of the reason I listed them $50 less than I paid. I figure that's about what it would cost in time/parts to clean them up.
Last edited by Ipecac; Oct 15, 2013 at 01:35 PM.