consolidated my FS threads here..

 

Here's what it looks like installed..

 

^ looks pimp. Might be a silly question, but is the all carbon radio bezel sized for an aftermarket double din, or is it the same size as for the oem non navi radio?

 

It's the JDM aftermarket double din one.. As in, if you put a double din radio, no kit needed to fill in the gaps on the side (eq. Metra)

see pic above, with my pioneer double din radio (no gaps).

Tomorrow, I may only have one set of STI (black) and STI (silver) left.

Somebody has dibs on 1 STI set / with the sills, and another - the WRX set..

 

That sucks that the GR isnt double din unless you order jdm.

 

By factory it is double din however like most radio installs you need to get the metra kit to get rid of the lines. I as well bought the JDM bezel so I can get rid of the lines when I was test fitting. But anyways.. Its a usdm thing vs JDM just like our ecus lol. Its all catering to the market.

 

I used the stock brackets and pushed the stereo forward a bit cause pioneers tend to be too sunk in. But then I had to trim the lip around the edge since it was bulged out.
Nice fit now. But of course this is on a gd not a gr

 

STI set all CF w/ Door sills gone - sold to JP STI (IWSTI). Shipping out tomorrow.

Only got the following left

1 Remaining set of STI Shifter Surround, JDM Double-Din Bezel (Black - all CF look)
1 Remaining set of STI Shifter Surround, JDM Double Din Bezel (W/ Silver + CF - Clear Coated)
1 Remaining set of WRX 5-speed Shifter Surround, JDM Double Din Bezel (Black - all CF look)..

WRX set may be gone tomorrow, somebody is interested in NASIOC.

Once it's gone - it's gone - lol. I'll take pics of my setup tomorrow.. Finally installed my shift and hand brake boot from Redline Goods..

 

Yeah, I had the stock Panel Hydro-Dipped also (not the JDM ones like bundled here) and sold it over at IWSTI with the Metra Kit (first set Greg Did). Pretty much needed for an aftermarket Single DIN-RADIO (metra has a cubby on the bottom).

The JDM one here doesn't need the Metra Kit if the radio is aftermarket Double-DIN. Doesn't make sense for an aftermarket single-din radio though as there would be a big hole on the bottom..

looked like this (stocker panel /w metra kit).

 

Can u hydro dip anything I need

 

The shop that did these for my - FXHydrographics out in BrentWood closed up shop. I don't believe there's another local hydro-dipping shop in the bay area that puts out quality work.

There's a bunch of mail-in ones though that will do it for you..

 

^bump.

 

PM'd.. Also have a Brand New Solid Modifications 08+ VentPod Gauge Pod 52mm - 65$ + shipping, or 60$ bundled with any of the pieces..

 

^bump. Last STI ALL-CF Look /w JDM Panel Sold! to Zero..

Only have the following left..

1) WRX all CF + JDM Bezel
1) STI Silver w/ CF + JDM Bezel w/ CF (Clear Coated).
1) Solid Mod 08+ VentPod

 

Got around to installing shifter surround today, thanks again.