Fs/ft aps topmont
banned
iTrader: (13)
Joined: Oct 2007
Posts: 2,746
From: Walnut Creek Ca..
Car Info: heel'n toe da hoe...
If its from the 2003 wrx you have listed under your name it will not fit.
The DBW Vs. Cable throttle bodies use differant TMIC's The DBW is over about a 1/2 inch. You can force it to fit. But its going to cause problems down the road.
The DBW Vs. Cable throttle bodies use differant TMIC's The DBW is over about a 1/2 inch. You can force it to fit. But its going to cause problems down the road.
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
then how can 07 sti tmic's fit on 02 wrx's? i've seen it put on. no problems
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
the 1/2 inch difference is made up on the turbo to intercooler. the y-pipe. the slack, or stretch is made up on how far the y pipe housing sits on the turbo
banned
iTrader: (13)
Joined: Oct 2007
Posts: 2,746
From: Walnut Creek Ca..
Car Info: heel'n toe da hoe...
Because the 02-03 do not have parts where the 2.5's do... I had this problem 1st hand. Also do a search on the part numbers. You will see there is two part numbers. Dont you think if one part fit both it would be cheaper for APS to sell one part.
banned
iTrader: (13)
Joined: Oct 2007
Posts: 2,746
From: Walnut Creek Ca..
Car Info: heel'n toe da hoe...
results my vary.. But I'd never do it again.
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
