02 WRX Wagon Part Out!! 99 RS SOHC Longblock & SRS-20 ECU!
General Pimpin'
iTrader: (7)
Joined: May 2003
Posts: 23,019
From: Knee deep in beer. subabrew crew, ca.
Car Info: MY04 aspen wrx wagon.
You were saying you need to get the dash all the way out and hopefully have time to get your RS one out... I'm saying spend the time getting your RS dash out as I have a WRX dash in my shed. Was just throwing it out there so you could get more work done on the RS if you wanted to. No biggy. I actually have an RS and WRX dash in my shed... and rs weather seals. STI master cylinder. WRX master cylinder. All kinds of weird isht. LOL!
Thread Starter
Old School
iTrader: (6)
Joined: Jan 2001
Posts: 14,983
From: Union City
Car Info: '99 RBP GM6
You were saying you need to get the dash all the way out and hopefully have time to get your RS one out... I'm saying spend the time getting your RS dash out as I have a WRX dash in my shed. Was just throwing it out there so you could get more work done on the RS if you wanted to. No biggy. I actually have an RS and WRX dash in my shed... and rs weather seals. STI master cylinder. WRX master cylinder. All kinds of weird isht. LOL!
Well, no matter what, have to rip the dash out of the wagon anyways to get to the harness. And yeah, that goes for both cars.
General Pimpin'
iTrader: (7)
Joined: May 2003
Posts: 23,019
From: Knee deep in beer. subabrew crew, ca.
Car Info: MY04 aspen wrx wagon.
General Pimpin'
iTrader: (7)
Joined: May 2003
Posts: 23,019
From: Knee deep in beer. subabrew crew, ca.
Car Info: MY04 aspen wrx wagon.
General Pimpin'
iTrader: (7)
Joined: May 2003
Posts: 23,019
From: Knee deep in beer. subabrew crew, ca.
Car Info: MY04 aspen wrx wagon.
It looks like there was some repair on the inside of the wheel. But for $100 I'd probably clean up the curb age and plastic dip them and rock em for a winter set.
Hey Gagan...
There should be a nut on the center post the rear seats mount too. I can't find mine.
So I have a possible pick up list...
windshield
headliner
that nut
and of the big plastic plugs that you can find that hold the rear hatch foam to the floor. I installed the floor this morning. Way more solid than my POS but those plugs would help a lot.
The little plastic clip that's on the driver side rear hatch area. I couldn't get it off for some reason.
So far I have the rear seats in and the rear floor. Looks WAAAAAY better. Thanks dude.
I may have to run some errands friday so if you need anything let me know. If I need to borrow my brother's truck to bring that engine stand or the picker down let me know. I have to get it down to Newark anyways. It's my buddies dad's and I've had it for like 6 friggin years. No joke. LOL!