WTB: BE JDM Taillights
Guest
Posts: n/a
Hey fibuz, were you the one who wrote up the technique for clearing the signals (I found on nasioc)?
Just wondering if you were....if you're not, care to inform me of how you did it? Anything I should know beyond preheating to 250, leave them in for 5-7 minutes?
Just wondering if you were....if you're not, care to inform me of how you did it? Anything I should know beyond preheating to 250, leave them in for 5-7 minutes?
VIP Member
Joined: Apr 2004
Posts: 122
From: USA
Car Info: Subaru
Originally Posted by BlanginBE
Hey fibuz, were you the one who wrote up the technique for clearing the signals (I found on nasioc)?
Just wondering if you were....if you're not, care to inform me of how you did it? Anything I should know beyond preheating to 250, leave them in for 5-7 minutes?
Just wondering if you were....if you're not, care to inform me of how you did it? Anything I should know beyond preheating to 250, leave them in for 5-7 minutes?
Whatever it said in the writeup is what it is...its been over a year since I did it, so my memory is foggy.I'd suggest checking it every minute or two to see what the plyability of the glue is...
as a general rule, the lower the temp the better, even if you have to wait longer.
also, I'd reccomend getting some caulk to seal up everything afterwards to prevent moisture from entering the housing.
good luck,
fibuz
Registered User
Joined: Oct 2004
Posts: 71
From: Japan
I may be able to find a set of BE Sedan Tails - they would not be as expensive as new ones but would not be too cheap either - I am estimating - $200.00 shipped for a set. First I have to check my local salvage yards to see if they even have any.
I am stationed here in the military.
I am stationed here in the military.
Thread
Thread Starter
Forum
Replies
Last Post
WhiTe_07_WRx
NorCal Classifieds
31
Jul 4, 2007 04:03 AM
manny183
Wanted
5
Mar 22, 2007 10:32 PM
lonesubyguy
NorCal Classifieds
3
Sep 20, 2006 06:43 PM
SNTRvicious06
NorCal Classifieds
5
Jun 27, 2006 10:59 PM
