I have searched, but have not found the information that I need.

I have a 2002 WRX, and I have the parts off of an STi for the I/C Sprayer. Specifically the I/C button, I/C control assembly (looks like a large relay), the sprayer tank, and pump.

My question is, using these parts, can I have it work the same way as it does in the STi? Where when the button is pushed it sprays for a pre-determined amount of time?

My next question is, I have the 2004 STi cluster also. It has a low fluid indicator for the sprayer tank. Is there a way to wire the sensor in the tank to the cluster to display when the fluid level is low?

Any help would be appreciated. I have my dash pulled out and want to get my gauges and everything done at the same time.

Nick

 

just wire it up and hold the button down for as long as you need to.

 

I understand that, but that is not what I want to do. In the STi, when you push the switch it sprays it for a certain amount of time. I was wondering how I can wire it in to do this if I have what I presume to be all of the parts that go to it.

Nick

 

I believe that is programmed into the STi's ECU not in the WRX's if I am correct.

 

I have a relay off of the STi that says I/C Assembly. Do you think it is only a realy, or do you think it could control the time as well?

Nick

 

there are timed relays. If that's true in the STi's case, it should work. Try searching www.scoobymods.com to see if installation instructions are posted. Post a new thread if there isn't on already there.

 

OK, I'll check that out.

Nick

 

Check out this link: http://www.clubwrx.net/forums/showth...cooler+sprayer