Winshield Washer Motor

Reply Subscribe

Thread Tools

Search this Thread

Feb 12, 2003 | 09:19 PM

GTMAN

Guest

Posts: n/a

Winshield Washer Motor

Hello Friends,

I have what I believe a non functional winshield fluid pump/motor for the rear liftgate on my 98GT Wagon. It does not make a motor buzzing noise like the front one when activated, and it does not spray out. Doubt its a clogged nozzel.

Does anyone know how to replace one of those motors? Instructions would be useful if there are any tricks involved. Looks like a decent task, but just want to be on the safe side before I bust into it this weekend.

Thanks in Advance,
GTMAN
98GT Wagon w/Eibach-Agx, Cusco, AVSDB's, K/N, 18mm rear swaybar.

Feb 13, 2003 | 04:13 AM

Peaty

Registered User

iTrader: (2)

Joined: Nov 2002

Posts: 1,644

From: Lawrence, Kansas

Car Info: 19' Impreza Sport Manual / 99 Miata / 13' OB

It's very simple. The washer pump is just pushed into the tank and held in place by a rubber gasket. Just remove the tank, 2 - 10mm bolts, unclip the harnesses and hoses. Then tilt it on it's side and tug the washer pump out.

Here is a pic of the gasket under the pump, I got a legacy bottle to use the second pumps hole to feed my headlamp washers. I pulled out the pump and pushed in a barb connector: