Well I purchased a recaro driver side seat and mounted it all in and everthing just now I have the four wire harness's laying there under the seat and the airbag light on. I went all through nazioc and read a ton of info on it and I understand that i need to do the 3.3 ohm resister trick to fix the airbag light, but my car has the heated seats in the front and just wondering if all I need to do is the resister trick and thats it? The driver seat is just a mess cause of all the wires and what not.
I also found this on the other forum which plugs in to replace the resistor trick.
http://subaru.spx.com/Detail.aspx?id=327

All input is appreciated.

thanks
Cameron

 

bump. opinions please

 

sorry, i have no valuable input but are you selling your old seats?

 

Well you only need to worry about the airbag lines, but I wouldn't know the repercussions of that though..