removing the radio bezel
Guest
Posts: n/a
removing the radio bezel
I'm somehow not seeing how to disconnect this....I have all the screws out from around the sides and the ones out from the ash tray...but I'm still hung up on something on the divider right below the CDplayer....any help?
1998 2.5GT-W
1998 2.5GT-W
iClub Silver Vendor
iTrader: (25)
Joined: Nov 2002
Posts: 15,494
From: Participating in some Anarchy!
Car Info: 2005 LGT wagon
This is how I remove the bezel:
Open the arm rest lid & remove the two screws (near the catch/lock thingy) that hold down the rear panel of the center console.
Lift the rear center console panel up & over the P-brake handle. Remove the two screws that secure the front panel (stick shift surround) of the center console. Lift the front panel up; If you have an auto, move the selector to to 1st gear.
I think there are then two screws that hold the bottom of the bezel in place.
Paul
Open the arm rest lid & remove the two screws (near the catch/lock thingy) that hold down the rear panel of the center console.
Lift the rear center console panel up & over the P-brake handle. Remove the two screws that secure the front panel (stick shift surround) of the center console. Lift the front panel up; If you have an auto, move the selector to to 1st gear.
I think there are then two screws that hold the bottom of the bezel in place.
Paul
Warm Fuzzy Admin
iTrader: (45)
Joined: Mar 2001
Posts: 13,799
From: Sacramento, CA
Car Info: 97 LOB, 05 FXT, 03 Tundra
Originally Posted by Oaf
This is how I remove the bezel:
Open the arm rest lid & remove the two screws (near the catch/lock thingy) that hold down the rear panel of the center console.
Lift the rear center console panel up & over the P-brake handle. Remove the two screws that secure the front panel (stick shift surround) of the center console. Lift the front panel up; If you have an auto, move the selector to to 1st gear.
I think there are then two screws that hold the bottom of the bezel in place.
Paul
Open the arm rest lid & remove the two screws (near the catch/lock thingy) that hold down the rear panel of the center console.
Lift the rear center console panel up & over the P-brake handle. Remove the two screws that secure the front panel (stick shift surround) of the center console. Lift the front panel up; If you have an auto, move the selector to to 1st gear.
I think there are then two screws that hold the bottom of the bezel in place.
Paul
On my car the only screws int he center consol were the rer ones, under the center console lid, but autos may be different. The shifter surround holds in the center piece becuase of the angles involved.
Thread
Thread Starter
Forum
Replies
Last Post