glare problem after jdm headlight mod (rhd to lhd)
#1
Registered User
Thread Starter
iTrader: (6)
Join Date: Jun 2003
Location: San Francisco
Posts: 551
Car Info: Audi B6 S4
glare problem after jdm headlight mod (rhd to lhd)
I did the mod where you grind off the mask to level it off so there's no rising cutoff. However after I installed the headlights back onto my car, there is a heap of light above the actual cutoff beam. I'm wondering if this has anything to do with the shiny metal exposed on the masking plate after you grind it off. I used a sharpie marker to fill in the shiny parts. Is that the problem here?
According to Imprezer's instructions (from i-club) on modding these lights, he said you can just use a black marker and paint over any shiny part.
What else can be the problem? The problem is present in both lights.
According to Imprezer's instructions (from i-club) on modding these lights, he said you can just use a black marker and paint over any shiny part.
What else can be the problem? The problem is present in both lights.
Thread
Thread Starter
Forum
Replies
Last Post
Badfish
Interior, Exterior & Lighting
76
07-06-2007 06:53 PM
spyguy
Interior, Exterior & Lighting
6
12-25-2002 12:54 AM