getting a wire through firewall ?
Guest
Posts: n/a
getting a wire through firewall ?
HI, I'm setting up water-tank float switch, and LED warning light on my dash to show me when water in washer-tank is running low, so I don't keep burning out those IC-spray pumps.
but I can't find how to get my wire through the firewall on my RS.
any tips please ?
thanks
Jon
but I can't find how to get my wire through the firewall on my RS.
any tips please ?
thanks
Jon
Registered User
Joined: Apr 2003
Posts: 17
From: Boulder, CO
Car Info: Stock 2001 WRX
Jon,
Just did this recently. I couldn't find any holes that I could run the wires through either so I drilled a hole in an open area of the firewall. The metal is very thin, I just about touched the bit to the metal and it went right through. After you and the hole edges and put the wires through you can just use roofing caulk to fill it.
Mike
Just did this recently. I couldn't find any holes that I could run the wires through either so I drilled a hole in an open area of the firewall. The metal is very thin, I just about touched the bit to the metal and it went right through. After you and the hole edges and put the wires through you can just use roofing caulk to fill it.
Mike
Guest
Posts: n/a
thanks mike,
I was just about to drill when I found another way,
Another existing cable (passing threough firewall) had lots of slack, so I taped my new wire to it, then pulled it through, then pulled the slack back again on the old wire
project complete : )
I was just about to drill when I found another way,
Another existing cable (passing threough firewall) had lots of slack, so I taped my new wire to it, then pulled it through, then pulled the slack back again on the old wire
project complete : )
Thread
Thread Starter
Forum
Replies
Last Post
04_ktown_wrx
Interior, Exterior & Lighting
1
Apr 15, 2006 09:23 PM
Imprezer
Engine/Power - EJ20T (pre-2006 WRX and JDM)
6
Jul 21, 2005 06:55 AM