front badge & fog light removal-help
Guest
Posts: n/a
front badge & fog light removal-help
I drive an '02 WRX sedan. Here are hopefully a few easy questions for someone:
1. I have a new badge for the front grill, what's the easiest way to remove the old one?
2. I need to replace a fog light that's blown. The manual says to take out three screws and pull out the fixture. Looks like the screws aren't easy to get at. Help? Thanks.
1. I have a new badge for the front grill, what's the easiest way to remove the old one?
2. I need to replace a fog light that's blown. The manual says to take out three screws and pull out the fixture. Looks like the screws aren't easy to get at. Help? Thanks.
Guest
Posts: n/a
emblem- use a heatgun/hairdryer to heat it up first. then take a
small - screw driver and pull it out. becareful not to dent the
trimming around the emblem.
fog-i think it was a 10mm nut. just get an extended socket
or a long + screw driver. very easy to do.
small - screw driver and pull it out. becareful not to dent the
trimming around the emblem.
fog-i think it was a 10mm nut. just get an extended socket
or a long + screw driver. very easy to do.
Guest
Posts: n/a
i dont know about the fog lights but for the badge take a small screwdriver with a blad thats not ver thick and put in the side and pry it off. I took a paper towel and put it over the blade of the screwdriver so it wouldn't scratch my grill. It comes of fairly easy. And when i repainted that badge and put it back on i used silicon instead of double backed tape, dont know which is better but i know silicone holds very good.
Thread
Thread Starter
Forum
Replies
Last Post
1FSTREX
NorCal Classifieds
4
Jun 26, 2009 06:07 PM
sjice
Used Aftermarket Car Parts For Sale
3
Feb 28, 2007 06:52 PM
DaFastOne
NorCal Classifieds
4
Jun 22, 2005 06:51 PM
DaFastOne
Used Aftermarket Car Parts For Sale
0
Jun 16, 2005 05:51 PM



