nw_sti_04

So the stock replacement bulb for the STi LowBeam is a HID D2R bulb that is 150$ at Carter Subaru I guess? But is there other HID bulbs that arent factory that will work assuming the temps are the same, thoughts?

Mulder

The retail on OEM HID bulbs is rather expensive. However if you look around online, including EBay, you can find them brand new for much less. Just be sure to get brand name bulbs (Phillips, Osram, Hella) in the proper type (D2R) and color temperature (4300K). Avoid aftermarket bulbs or higher color temps.

nw_sti_04

and once again, my question is answered, thanks

nw_sti_04

got a new D2R bulb, put it in there and guess what? no headlight, could this be the ballast or power source not working or what?

Mulder

Have you by any chance opened your headlights to clear them, or has a previous owner done so? If so it's possible they were not fully resealed and water has gotten in them, disabling the ballast. This is a common occurrence when STi lights are cleared. If this has happened you may be able to remove the ballast and dry it out, if it still does not work it will need to be replaced.
You should also check the headlight fuses to see if one has blown.
The original bulb can be tested by swapping it into the light on the other side that still works, that will confirm if is actually good.

nw_sti_04

sure enough after reading a few posts, i pull out my headlight, yes they have been cleared and sure enough ahhh water....woohoo. they are in the over right now, and i am getting a heat gun to dry out the ballast, I will keep you posted, thanks man

Mulder

Good luck, I figured as much since this is about the only reason for the STi HIDs to fail, they are very reliable otherwise.