Cupholder Lid for 2008-2010 WRX console?
11-17-2010, 08:39 AM
#6
Registered User
iTrader: (5)
Join Date: Jul 2010
Location: Manteca
Posts: 1,226
Car Info: 2010 Impreza 2.5i Premium Boosted
I agree with Jourdan. They Legacy center consol is CLASSY. but you would have to work with it a bit to get it to fit right in and the seat warmer buttons and different spot. but the cup holder slider is dope.
11-17-2010, 09:08 AM
#7
The Legacy console is almost a direct swap.
I put the legacy gt console in my car, has a slide lid like the STI but has seat heater buttons instead of the diff control buttons. Had to mod it a bit to fit, but it's the look I was going for.
I got it from an LGT owner and I just had to pay shipping. The top is not the faux leather texture but just a smooth matte finish. The mounts up front do not match up and you'll have to pull off the front passenger side shifter wall and dremmel off the mount to fit the seat heater control in there. I tried to build a mount but that didn't happen. It fits but if you pull up the front part of the console it will lift out. It's being held in to the shifter trim by the e-brake boot
I got it from an LGT owner and I just had to pay shipping. The top is not the faux leather texture but just a smooth matte finish. The mounts up front do not match up and you'll have to pull off the front passenger side shifter wall and dremmel off the mount to fit the seat heater control in there. I tried to build a mount but that didn't happen. It fits but if you pull up the front part of the console it will lift out. It's being held in to the shifter trim by the e-brake boot
Last edited by JourdanWithaU; 11-17-2010 at 09:12 AM.
Thread
Thread Starter
Forum
Replies
Last Post
LOL_VTEC
NorCal Classifieds
2
08-06-2009 06:47 AM
bambams247
Wanted
2
09-11-2004 05:20 AM
