Hawaii Classifieds Cars, parts, electronics, etc for sale and trade. Private parties and approved regional i-Club Vendors.

Thinking about parting out my 07 WRX

Thread Tools
 
Search this Thread
 
Old Jun 12, 2012 | 06:50 PM
  #1  
spinplay01's Avatar
Thread Starter
Registered User
iTrader: (12)
 
Joined: Dec 2009
Posts: 965
From: Ice Palace...not the meth lab, the skating rink.
Car Info: 1995 dodge neon
Thinking about parting out my 07 WRX

Would be looking for cash plus stock parts.

All parts are close to new condition and have less than 1,000 miles

Will go through with it if I have a buyer for engine, trans, and turbo set up.

OR give me your stock STI plus a little cash for the whole car. You Will save $ on insurance. haha
17k miles, very expensive 2 stage satin paint job. near perfect exterior.
Name:  CCD_0003small.jpg
Views: 54
Size:  137.3 KB


Engine:

Sti Crankshaft
Sti Block Halves
2008 11mm oil pump
Sleeved
Bluprinted and Balanced rotating assembly
ACL Race Bearings
K1 Rods
Manley Pistons

Heads:

GSC S2 Cams
Race Port sti heads
Valve Job 5 Angle intake and 3 angle exhaust
Supertech Titanium Valves
Supertech Titanium Springs and Retainers
ARP Head Studs
Gates racing timing belt

Long block
$6,000 plus working stock AVCS long block

Name:  DSC_0786.jpg
Views: 48
Size:  136.6 KB



Turbo:

Full Race Header+twinscroll up pipe
Full Race V-Band Downpipe
Twin-scroll Borg Warner 83-75 with 1.00 A/R Hotside (bigger than gt35)
Dual Tial 38mm wastegates with dump pipe
4 inch turbo inlet
Autometer Wideband with gauge

$5,500 plus stock or non-rotated setup.

Name:  07wrxengine.jpg
Views: 73
Size:  87.3 KB



APS DR725 Stealth Front Mount Intercooler for rotated turbo
$700


Fuel:

1200cc Five-0 Injectors
Aeromotive Fuel Pressure regulator
Aeromotive Fuel Rails
TGV deletes
Anti-Surge Tank
Bosch 044 fuel Pump after surge tank
3/8 i.d. fuel lines from tank to rails

$1000 plus trade entire intake manifold, hard fuel lines, rails, wiring

Name:  07wrxfuel.jpg
Views: 84
Size:  74.6 KB



Transmission:

ACT 6 puck solid state clutch disc
ACT heavy duty pressure plate
F1 13 lb flywheel
PAR 650 HP Straight-cut 5 Spd Gearset
(Similar to PPG, very loud transmission)
PPG transfer gears
Kaaz Front LSD

(cracked bell housing from shattered clutch... works fine as is or could be repaired)

$3250 plus stock trans/clutch/flywheel (PAR gearset alone was $5500)



Grimspeed boost controller
$75 plus stock

Greddy Strut top bars
$250


Greddy oil catch can
$50


Samco hoses
Koyo radiator
$250 + stock quickboy


Sway bar end links
Whiteline sway bars and bushings
$300 + stock Sigterm


KW Varient 3 coilovers
$1300 + stock suspension or similar Krang


Exterior:

Carbon grille
$75

Carbon hood scoop delete
$150 plus stock


06-07 STI HID headlights
$600

Last edited by spinplay01; Jun 14, 2012 at 04:20 PM.
Old Jun 12, 2012 | 06:58 PM
  #2  
spinplay01's Avatar
Thread Starter
Registered User
iTrader: (12)
 
Joined: Dec 2009
Posts: 965
From: Ice Palace...not the meth lab, the skating rink.
Car Info: 1995 dodge neon
Sorry mods. misplaced.

Please move to classifieds.
Old Jun 12, 2012 | 09:12 PM
  #3  
Ditchhanger's Avatar
Staff Member
iTrader: (16)
 
Joined: Nov 2002
Posts: 3,644
From: She's so hot, I'd tongue-punch her in the fartbox
Car Info: 2001 RSTi Widebody
No problem...moved
Old Jun 12, 2012 | 09:16 PM
  #4  
Javirex23's Avatar
Registered User
iTrader: (17)
 
Joined: Oct 2008
Posts: 2,178
From: Bay Area
Car Info: 07lmtd 6spd wrx eq tuned
I must ask, what were the #'s you put down with this setup?
Old Jun 12, 2012 | 09:38 PM
  #5  
reconisbologna's Avatar
Registered User
iTrader: (6)
 
Joined: Jul 2007
Posts: 363
From: Grass Hut, HI.
Car Info: Yimi Sport Tuned VF39'd 2.0L
Chad, Great price on your longblock +the additional avcs longlock...
Old Jun 12, 2012 | 11:34 PM
  #6  
no_way56's Avatar
Registered User
 
Joined: Aug 2006
Posts: 388
From: HONOLULU
Car Info: 06 WRX WAGON LIMITED
hey chad are the swaybars on the sedan interchangable with a wagon?
Old Jun 13, 2012 | 01:35 AM
  #7  
spinplay01's Avatar
Thread Starter
Registered User
iTrader: (12)
 
Joined: Dec 2009
Posts: 965
From: Ice Palace...not the meth lab, the skating rink.
Car Info: 1995 dodge neon
Originally Posted by no_way56
hey chad are the swaybars on the sedan interchangable with a wagon?
I know the wagon control arms are shorter, but i dont know if the mounting points for the endl links changed position. They are probably the same, because it doesnt make sense from a finacial point to change 2 parts when only one could be changed...and one is already changed.

But it didnt make sense to change the stance of the wagon to begin with...so who knows. lol

It would be a simple google search to find out. Good luck with that.

I still have your top mount and up pipe btw. haha

let mw know when you want to pick up.
Old Jun 13, 2012 | 01:40 AM
  #8  
spinplay01's Avatar
Thread Starter
Registered User
iTrader: (12)
 
Joined: Dec 2009
Posts: 965
From: Ice Palace...not the meth lab, the skating rink.
Car Info: 1995 dodge neon
Originally Posted by Javirex23
I must ask, what were the #'s you put down with this setup?
It is enough. It can lose traction in a straight line at freeway speed.
Old Jun 13, 2012 | 04:26 AM
  #9  
JunkPirate's Avatar
Registered User
 
Joined: Feb 2012
Posts: 193
From: Kaneohe Bay, Hawaii
Car Info: 09 STI
Wannnnttttttt
Old Jun 13, 2012 | 09:43 AM
  #10  
PSBeachBum's Avatar
Registered User
iTrader: (11)
 
Joined: Feb 2011
Posts: 2,106
From: Red Hill
Car Info: my wife crazy with buying parts
the sways..... do you have just the rears 4 sale?? Wundering ya know because i rox a wagon and according to my research the 02-07 rears are all the same fitment. what size??

Also the oil catch can..... include any mounting hardware or a little help installing or being told how to install.??
Old Jun 13, 2012 | 12:32 PM
  #11  
sadc's Avatar
Registered User
 
Joined: Oct 2006
Posts: 75
From: kapolei
Car Info: 1997 Mitsubishi eclipse gsx awd turbod
damn I thought you sold this along time ago....bump
Old Jun 13, 2012 | 12:53 PM
  #12  
spinplay01's Avatar
Thread Starter
Registered User
iTrader: (12)
 
Joined: Dec 2009
Posts: 965
From: Ice Palace...not the meth lab, the skating rink.
Car Info: 1995 dodge neon
Originally Posted by PSBeachBum
the sways..... do you have just the rears 4 sale?? Wundering ya know because i rox a wagon and according to my research the 02-07 rears are all the same fitment. what size??

Also the oil catch can..... include any mounting hardware or a little help installing or being told how to install.??
Sway bars, bushings, and end links not sold seperately or without trade for stock.

Catch can only. Simple install. Learning how to do it is actually easier than asking the question of how to install it...

Name:  googlecatchcaninstall.jpg
Views: 92
Size:  114.6 KB
Old Jun 13, 2012 | 01:00 PM
  #13  
jblanco325's Avatar
Registered User
iTrader: (1)
 
Joined: Dec 2006
Posts: 309
From: Nor-Cal
Car Info: 05 WRXie
^ yes!! 'wtf what is a google' LOL!!!
Old Jun 13, 2012 | 05:15 PM
  #14  
houdni's Avatar
Registered User
iTrader: (1)
 
Joined: Jun 2005
Posts: 1,129
From: K@ilu@, H@w@ii
Car Info: 06 STi
MEAN!!! GLWS....bump
Old Jun 13, 2012 | 11:55 PM
  #15  
no_way56's Avatar
Registered User
 
Joined: Aug 2006
Posts: 388
From: HONOLULU
Car Info: 06 WRX WAGON LIMITED
Originally Posted by spinplay01

I still have your top mount and up pipe btw. haha

let mw know when you want to pick up.
haha. i thought you got rid of it. since i said i would come but didnt show. i'll let you know when i can come by. thanks for holding it for me. btw the exhaust leak came back.



All times are GMT -7. The time now is 11:01 AM.