TiC 5MT Lever Pivot Bushings

Reply Subscribe

Thread Tools

Search this Thread

May 24, 2006 | 01:08 AM

#31

oldmansan

Registered User

iTrader: (4)

Joined: Dec 2002

Posts: 2,176

From: Southern California

Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco

If the stock sleeve will work I've got mine. Post up either way.

San

May 24, 2006 | 06:12 AM

#32

bpang1

Thread Starter

VIP Member

iTrader: (25)

Joined: Aug 2004

Posts: 7,925

From: Spokane, WA

Car Info: '04 WRX Wagon

Quote:

Originally Posted by cboggess

Shoot!! Was that my screw-up? Shoot me an email and I'll get a new sleeve out to you. Keep those bushings as they are the same for either version, it's just the sleeve length that is different.

Hey it's Clint!

May 24, 2006 | 10:35 AM

#33

91sleeper

Registered User

iTrader: (13)

Joined: Sep 2005

Posts: 1,862

From: Wagon on the outside....STI on the inside!!

Car Info: 04 XTi.............. Seats down..G's up

Quote:

Originally Posted by BattleD01

dammit I got the wrong one hahaha the metal piece its to lng I have a stock shifter and the stock metal piece is shorter dammit!...

yeah i almost made the mistake of ordering the wide ones. make sure you have the narrow ones as our cars (pre 02 impreza) require them. luckily i realized my mistake and e-mailed TiC and they were very prompt in their responce and i am happy. i should have mine in today.

May 24, 2006 | 12:40 PM

#34

cboggess

Registered User

Joined: Aug 2003

Posts: 24

Quote:

Originally Posted by oldmansan

If the stock sleeve will work I've got mine. Post up either way.

San

Sadly the stock sleeve will not work.

The rule of thumb is this:

01 and earlier get the narrow verion
SPT/STi factory short shifter for all years gets the narrow version
02 and up with the stock shifter assembly gets the wide version.

Last edited by cboggess; May 24, 2006 at 01:20 PM.

May 24, 2006 | 06:38 PM

#35

oldmansan

Registered User

iTrader: (4)

Joined: Dec 2002

Posts: 2,176

From: Southern California

Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco

Something is up with mine. It feels like it's binding going into gear, but not side to side, just up and down. I'm going to take it apart and regrease. I torqued it down with my torque wrench but maybe it's too tight? I'll check the length against stock also. I'll post up later.

San

May 24, 2006 | 10:40 PM

#36

oldmansan

Registered User

iTrader: (4)

Joined: Dec 2002

Posts: 2,176

From: Southern California

Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco

I'll just have to say I have no reference as my stock shifter assembly was so loose (before install). I did find that the torque recommendations on the install didn't work very well for me and I went lower (70 inch-lbs, or nearly 6 ft-lbs). Just felt a bit quicker with less torque.

San