Merry Christmas, i-club! One more meat before Xmas! Come out! See you there!

This is the one by Byron's Drive Inn.

 

 

I might be able to actually make a meet finally! Imma bring some basic tools and my Shiny new Perrin Crank Pulley, if anyone is down for an assisted install. If not i have a perfectly good garage, just havent gotten around to doing it

 

basic tools wont cut it for that job

 

Lol you want to do a crank pully at a meat?

 

I'm definitely going, i just gotta see this bling bling pulley in action!

 

might finally make this one too, if for a bit, but will see ya'll there

 

Yeah just saw that thing ya gotta put on the pulley to hold it in place....i guess ill just go to the hobby shop

 

Want to put some money on that shaggy?


3/8" socket wrench, 10mm socket, 12mm socket, 6" socket estension, pliers, short 22mm 1/2" impact socket, 1/2" breaker bar, 2-3lb hammer.


challenge?

 

you and I both know this is not part of your basic tool set.

 

Aside from an impact socket that's in my basic tool box. I guess I must be intermediate in the tool department.