I would like to install my new endlinks. I just got them in yesterday. I was hoping to do this sometime on Saturday. Probably morning timeframe. I need to get a jack but I may end up going to Hickam Hobby Shop to do it. Shouldn't take long but need to replace them before my factory links snap. Let me know if you are willing to help me out. Later.

DrV

 

you don't need jackstands. you want to keep the load on the suspension or you will have a hard time getting the endlinks installed. now if your car is too low to crawl under then get some ramps. all it takes is two 14mm wrenches remove the two bolts and then install the new endlinks in place of old one. repeat on other side.

 

Cool...thanks so much. probably much easier replacing the links instead of the entire bar. Sweet.

 

I've got 2 ramps, Jason. Let me know if you need a hand. I get off duty Saturday morning @ 8.

 

Where did you get them at??

 

I bought them at Schuck's (Checkers) in Washington over a year ago. We used them to put Sykosis' Nur-Spec on at Jason's place. I think you had left by then, though. You need to borrow them? I think they were only around $30 when I bought them.

 

I meant the End links...I have a set of ramps..

 

My bad! lol

 

I got the endlinks from Mike at MJPerformance. I got the Whiteline KLC32 set. I sent you a PM Jermiah. Jason, if you want I maybe meeting at Jermiah's place around 10am on Hickam. If you want, stop on over. Waiting for confirmation from Jermiah. The cost of the set with shipping was $105.