Chibby,
Thread Starter
Registered User
iTrader: (4)
Joined: Dec 2002
Posts: 2,176
From: Southern California
Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco
Chibby,
This info is from Ron at Axis
"Bone stock vers8 spec c heads flowed 260cfm @.400 lift on the intake and 195cfm@.400 lift on the exhaust. This was done on a superflow bench with 25" mercury. The water method might show slightly higher numbers."
San
"Bone stock vers8 spec c heads flowed 260cfm @.400 lift on the intake and 195cfm@.400 lift on the exhaust. This was done on a superflow bench with 25" mercury. The water method might show slightly higher numbers."
San
VIP Member
iTrader: (3)
Joined: Nov 2002
Posts: 10,133
From: Lastweek Lane - Watertown, NY
Car Info: 02WRXpseudoSTiWannabeWagon
Good reading, but doesn't specifically address neither US STI nor JUN.
http://www.teamnabr.com/pubforums/ul...c;f=9;t=000031
http://www.teamnabr.com/pubforums/ul...c;f=9;t=000031
Thread Starter
Registered User
iTrader: (4)
Joined: Dec 2002
Posts: 2,176
From: Southern California
Car Info: 2016 Z51 C7, 2007 Exige S, 2008 ZX-10R, 2016 Taco
I took the small excerpt
from a NASOC thread asking about JDM heads. Lots of pics showing differences. Heads are expensive!
San
San
VIP Member
iTrader: (3)
Joined: Nov 2002
Posts: 10,133
From: Lastweek Lane - Watertown, NY
Car Info: 02WRXpseudoSTiWannabeWagon
Oh shoot. I was describing the thread I was linking to, not what you were saying. I was just trying to add cam info to what you said.
Thread
Thread Starter
Forum
Replies
Last Post