So I'm so close to finally saving up for some Bride Gias Low Max seats. I did some research but I need some confirmation from guys who actually have aftermarket seats in their STi. So I would need:

3.3ohm resistor for air bag fix
Wedge Engineering brackets
Bride sliders
some misc Grade 8 bolts

Anything I'm missing? Also, since i'm short (5' 8"), will I be able to add spacers to the brackets to make the seat a little higher.

 

you need a buyer for your sti seats.


Maybe I could be that guy.

 

Lol!

 

Owned!!

Just put a Bride seat in my Z..Just needed the right resistor and correct slider...
Should be the same for the STI,..NASIOC has a thread on this...

http://forums.nasioc.com/forums/show...=bride+install

 

lol i couldnt stop laughing at spinplay's post!

 

My recaros came with brackets, rails, and hardware...I did the airbag fix with the resistors...so yeah, I think you're good....
I don't rock any spacers but I probably should...think I look like a midget driving heheheh

 

You don't need the wedge engineering brackets if you just get the Bride seat rails. The Bride seat rails combine the sliders and bracket.