does anyone have a diagram of how to install the carbon fiber roof spoiler or have any shop in the bay area that the installation, cause i dont wanna screw it up by drilling the wrong holes...... so any ideas will be helpful. thanks

 

Did you get the Bayson R one? I'd be interested in how the installation goes because i've been thinking about getting one of these.

 

yea i actually just bought the last one from them and sold it to me for $50 which was a good deal from $110, but yea i'm looking for shops that knows how to install it cause i dont wanna do it myself

 

50 Bucks!?!?!!! nice pick up

 

yea might go back tmr cause a friend of mine might pick up a mines carbon truck, but i'll ask him if he have any more cause i have a few buddies of mine that wanna buy one

 

do it yourself, its very simple. It just takes time and some kajones (*****).
put double sided sticky tape on each end and put on the car where you think it looks level. take 30 measurements and than double check those all again, when your good with the placement, COMPLETELY mark around the end caps with sharpie, not just the holes.
NOW, once its marked you get a center punch and you drill ONE hole, put the spoiler up there and put a bolt thru it, make sure ****s still is lined up good. Repeat this process until all holes are drilled.

and i forgot to add, DO NOT drill thru all 3 layers of sheet-metal!!! (this is stupid that people actually do this)
Drill thru the outside layer and ONLY the outside layer. Go to the hardware store and buy short stainless steel wall anchors http://www.almabolt.com/images/mason...allanchors.gif Those will suck up to the top later for sheet metal and hold the spoiler on stronger than you need, do not over tighten.

Before you screw it down, get a clay bar and a rag with some WD-40 on it to get that sharpie right off, Than just put the damn wing one


***Im not responsible for any mistakes YOU might make***
GoodLuck

 

^^ lol good luck or you can just 3M that sucka down. Lol