Bugout

greetings,
so ive been doing my nightly google research on WRXs with straight pipes and i came to the conclusion that its "budget" enough that i can take a shot at it.
so what i was looking for (if possible) is a list of sites or info on the catback set-up. a good friend of mine is a master welder and happens to have a pipe bender at our disposal (not to mention a LOT of beer, ).
im going to stop by my local shop tomorrow and get a quote on some 3inch pipes; if theyre cheap enough i'll probably just buy them and schedule a time to start the project.
any info on the sedan Y-pipe setup would be extremely useful.

thanks again
buGS

wrxisthebest

iTrader: (15)

just make it a single exit exhaust but chose a side you want it to exit and just use your oem catback as a guide for where you should put your piping...

ScoobySon

iTrader: (4)

and then post a clip of how it sounds soon after.

Bugout

i thought about doing that and maybe filling the empty exhaust gap with a toe hook or something. if i do go that route, i'd consider a 4" piping...

o no doubt, i have the equipment to mic up a good audio bite as well...

eclipsefirenos

iTrader: (1)

Sounds like a great project. I'd love to hear the result as well, lol.
Not to mention see the pictures!
Best of luck to ya!

Bugout

thanks. as of right this second everything's moving a little slower on the project build. i think it has to do with the crappy weather in NH lately. but no fear hopefully i'll make some progress this weekend....