EcuTeK STi reprogramming results
Guest
Posts: n/a
EcuTeK STi reprogramming results
Initial results from our dyno development work.
This is using 98 RON pump fuel (93 MON) and tested on our MAHA dyno.
These results were obtained after many tests carried out in a repeatable manner with cell temperatures and pressures within 1% of each other.
Please don't ask for wheel horsepower figures because we do not use them on our dyno. We are simply looking for percentage improvements based on the stock car showing almost exactly 300bhp on our dyno.
The car had covered 4000 miles before testing was carried out
This is using 98 RON pump fuel (93 MON) and tested on our MAHA dyno.
These results were obtained after many tests carried out in a repeatable manner with cell temperatures and pressures within 1% of each other.
Please don't ask for wheel horsepower figures because we do not use them on our dyno. We are simply looking for percentage improvements based on the stock car showing almost exactly 300bhp on our dyno.
The car had covered 4000 miles before testing was carried out
Thread
Thread Starter
Forum
Replies
Last Post