How to take apart a GFB Stealth FX BOV?
02-05-2004, 02:37 PM
#2
VIP Member
iTrader: (14)
Join Date: May 2003
Location: Wherever Sucks the Most
Posts: 8,675
Car Info: 2003 WRX, 2008 Camry
When I had a GFB stealth it said cleaning and oiling wasn't needed because it would get a lot of blow-off oil. It also says not to take it apart. you'll need to email GFB for cleaing instructions or maybe a internal diagram.
eric
eric
02-05-2004, 06:24 PM
#3
VIP Member
iTrader: (9)
Join Date: Nov 2003
Location: Seattle
Posts: 773
Car Info: 2004 WRBlue WRX sedan
Originally posted by Sisqocqk
When I had a GFB stealth it said cleaning and oiling wasn't needed because it would get a lot of blow-off oil. It also says not to take it apart. you'll need to email GFB for cleaing instructions or maybe a internal diagram.
eric
When I had a GFB stealth it said cleaning and oiling wasn't needed because it would get a lot of blow-off oil. It also says not to take it apart. you'll need to email GFB for cleaing instructions or maybe a internal diagram.
eric
02-08-2004, 10:48 PM
#4
https://www.i-club.com/forums/showth...&pagenumber=21
hope this helps. i myself havent done it yet (no time lately). If you take yours apart, tell me how it all went. good luck
hope this helps. i myself havent done it yet (no time lately). If you take yours apart, tell me how it all went. good luck
Thread
Thread Starter
Forum
Replies
Last Post
xqwizit
Interior, Exterior & Lighting
3
05-07-2007 05:07 PM
Cashis
Bay Area
37
05-08-2006 11:09 AM
jroh_spice
Engine/Power - EJ20T (pre-2006 WRX and JDM)
11
02-09-2004 12:07 AM
gbmotorsports
Bay Area
13
04-17-2003 11:28 PM
blow, bov, clean, cleaning, disassemble, disassembly, engine, fx, gfb, instructions, respons, stealth, valve
