Help with line connection

Reply Subscribe

Thread Tools

Search this Thread

Oct 11, 2007 | 01:28 PM

Rick539

Thread Starter

Registered User

Joined: Apr 2003

Posts: 57

From: Wichita, KS

Car Info: 2003 WRX Wagon

Help with line connection

Finishing my hybrid and cannot find or remember where the line below connects to under the intake. One end connects to the top tit on tumbler generator valve actuator on the driver's side but can not find where it attaches to. Thanks for any help

Attached Thumbnails

Help with line connection-picture_027.jpg

Oct 12, 2007 | 07:03 PM

Rick539

Thread Starter

Registered User

Joined: Apr 2003

Posts: 57

From: Wichita, KS

Car Info: 2003 WRX Wagon

Surley some one can go out to their car and check. It is on a 03 WRX. The line is the one that is running underneath the wiring harness tie.

Oct 15, 2007 | 09:17 AM

sigma pi

9 to 5 mod

iTrader: (6)

Joined: Jan 2003

Posts: 57,389

From: Chavez Ravine

Car Info: 03 Impreza WRX

sorry teh pic didnt work

try again and post it

Oct 24, 2007 | 10:20 AM

seri_808

Registered User

Joined: Jan 2005

Posts: 47

From: Kauai, HI

Car Info: 03 wrx

i have this same problem...i'm guessing the hose is just on there so that no type of water or moisture can get into the vacuum line. I took a look at the inside of the end of the hose and it seemed a little dirty versus the other hoses that i had unconnected for the downtime were clean. I'll try and take a pic today and upload it.....