Got a quick question here. I purchased an b&b downpipe from a guy on ebay, Downpipe looks great except one thing, it is a divorced wastegate design but there is no plate sticking out to seperate the two ports, is there any problems with that? or will I just not benefit from the divorced wastegate port as if it did have the plate?

 

It will be better than stock...but if your creative add one in. Find a Perrin measure it up and build your own.

 

well I can weld one in that isnt a problem. can someone mesure how far it sticks out from the flange and also how wide it is?

 

nm this post I used a picture of another downpipe and printed it out to size and marked mine to where the piece starts and stops, I only need to know how far the divider sticks out from the flange is someone could give me that info please! thanks