turbo oil supply line question
Thread Starter
Registered User
iTrader: (38)
Joined: Jun 2003
Posts: 1,236
From: San Ramon, CA
Car Info: 91 legacy, 87 mr2, 17 forester xt
turbo oil supply line question
hello all,
turbo is getting rebuilt. should i go with stainless steel oil supply lines for the turbo? turbo is a jdm td05-16g with 90 degree inlet for the 91 legacy.
if so, where to get them?
thanks.
turbo is getting rebuilt. should i go with stainless steel oil supply lines for the turbo? turbo is a jdm td05-16g with 90 degree inlet for the 91 legacy.
if so, where to get them?
thanks.
Last edited by chochocho; Feb 12, 2009 at 12:08 PM.
Search around on LegacyGT.com, there are numerous people who bought/made their own stainless oil supply lines instead of getting the dealer supplied parts during the recent recall for LGT turbo oil lines. All I needed was a new bracket, not lines, fortunately, so I dunno where to get them
banned
iTrader: (13)
Joined: Oct 2007
Posts: 2,746
From: Walnut Creek Ca..
Car Info: heel'n toe da hoe...
Chewwwwy
iTrader: (5)
Joined: Nov 2002
Posts: 3,399
From: Fremont
Car Info: Random, yet well planed selection of jdm cult cars
you can get the stuff to build your own at vic hubbard in hayward.
you will need some -3 or -4 pre-made an line, a banjo fitting (most likely 10mm), and a threaded fitting to attach to the block.
you will need some -3 or -4 pre-made an line, a banjo fitting (most likely 10mm), and a threaded fitting to attach to the block.
http://www.pandlmotorsports.com/osCo...roducts_id=435
Not too sure if this is it. But something similar perhaps. Might be worth it to give them a call.
Not too sure if this is it. But something similar perhaps. Might be worth it to give them a call.
Thread Starter
Registered User
iTrader: (38)
Joined: Jun 2003
Posts: 1,236
From: San Ramon, CA
Car Info: 91 legacy, 87 mr2, 17 forester xt
Thread
Thread Starter
Forum
Replies
Last Post
sWagonRX
Engine/Power - EJ20T (pre-2006 WRX and JDM)
1
Jul 6, 2012 12:20 PM
