prodrive uk300 headlight install help
#1
Registered User
Thread Starter
iTrader: (7)
Join Date: Jul 2007
Location: San Fran-Mateo
Posts: 894
Car Info: 2012 G37S / Sold 06 WRX
prodrive uk300 headlight install help
Ok so I just got a pair of prodrive uk300 that came with HIDs. I want to avoid splicing and found the thread on scoobymods here for JDM HIDs.
I can follow the same install info right?
if so, then all I would need to get would be this right? Or would it better to get this harness to use b/c I don't have a relay right now but otherwise nothing else besides the double sided tape to hold down the ballasts is required right?
should I be concerned that I have no relay right now? is one necessary?
Thanks for your help?
I can follow the same install info right?
if so, then all I would need to get would be this right? Or would it better to get this harness to use b/c I don't have a relay right now but otherwise nothing else besides the double sided tape to hold down the ballasts is required right?
should I be concerned that I have no relay right now? is one necessary?
Thanks for your help?
Last edited by vik682; 09-13-2007 at 06:52 PM.
#2
I have HID's and don't have a relay. It helps mainly for the flash to pass ability. That plug adapter should work just fine. just cut off the 9006 end and splice them into the prodrive lights and plug them in. Make sure you wire your ballast correctly. You might blow a fuse.
Thread
Thread Starter
Forum
Replies
Last Post
rossscarbro
Wanted
3
04-24-2004 06:03 PM