I was wondering if i can get some info on some of the pin-outs from the control unit (tiny molex connector) to the extension wire to the sensor. I need the pin outs for the OIL pressure, OIL temp. and Coolant temp. The help would be great,Thanks.
Basically i think they run a red,white and black wire for each 3 wire sensor, i need to know the order of the molex connector so i can make my own harness. If you have these sensors i just need a picture of the bottom of your control unit.

 

I am confused. I am sure I can help, but not sure what you are asking...

 

My wires that lead from the control unit through the firewall to the sensors are missing.....lost in my recent move. I contacted Tein (US dist. for Defi) and they said these wire are not easy to get. This is where you help comes in. I need to look at how the wires are setup on the molex connector on the control unit (colors). This way i can make my own. I have the control unit wire to the gauges, and sensors but no harness from the sensors to the controller. Hope this helps.

 

pin outs?? its a plug and play system you daisy chain your guages to the control unit give the control unit power and ground and a light input, plug in your sensors in and go
they all come with all the harnesses and connectors and the instructions are even in english

 

Did you read the post?????? I know how these things work and how they go together. I'M MISSING THE WIRES!!!!!! AND CANNOT GET THEM REPLACED, I WANT TO MAKE MY OWN SO I MAY USE MY GAUGES!!!!! I cannot make them if i don't know how the originals were wired. Basically everything is hooked up except for the wire from the sensor to the controller. This is what i need.

 

Ok. I will look it up for you. I should be able to do it tommorow. My car is at work.

 

Calm down buddy

 

yes

 

Deep breath.....in/out....much better now, thanks. Now if i can only find my brown paper bag. Sucker!

 

Thanks a lot!!!!!