Need help! URGENT!!!
Thread Starter
Registered User
iTrader: (4)
Joined: Jul 2011
Posts: 3,334
From: San Jose, Ca
Car Info: '06 WRB STi
Need help! URGENT!!!
So I started up my car after being in class for 3 hours or so and the car is acting extremely weird. The startup "sweep" of the gauges take 30 or so seconds. At idle, it says my car is idling at 3k rpm and when I give it a little gas it can go up all the way pass 9k rpm. I drove it down the street and even though I was going 25-30mph it was showing that I was going 120+.
Also the temperature and mileage screens are flickering when on and there is an electrical ringing noise when the ignition is on.
Also the temperature and mileage screens are flickering when on and there is an electrical ringing noise when the ignition is on.
Registered User
iTrader: (23)
Joined: Feb 2009
Posts: 2,674
From: South SF
Car Info: 97' Dodge Cummins and an RSTI thingie
You definitely have some sort of electrical issue going on, does the car feel normal? It could be that the connector for the cluster is loose or has a short.
How well did it start?
How well did it start?
First try disconnecting the positive of the battery to reset the system. If that doesn't work then try something else. But always start with something really basic, to debug the issue.
Registered User
iTrader: (23)
Joined: Feb 2009
Posts: 2,674
From: South SF
Car Info: 97' Dodge Cummins and an RSTI thingie
If it started well, I doubt its your battery or charging system, so like above I'd recommend disconnecting your battery and letting it sit for a few minutes, then reconnecting so it can reset the ECU.
If that doesn't work I would pull out the cluster (only a few screws, and you don't have to pull it all the way out) and give a firm press on the 3 connectors, there's one on each top corner and in the top center.
If that doesn't work I would pull out the cluster (only a few screws, and you don't have to pull it all the way out) and give a firm press on the 3 connectors, there's one on each top corner and in the top center.
Thread Starter
Registered User
iTrader: (4)
Joined: Jul 2011
Posts: 3,334
From: San Jose, Ca
Car Info: '06 WRB STi
Well I just drove over to the auto shop class and borrowed a wrench to take off the positive terminal and all is new again.
Thanks for the quick responses everyone!
Thanks for the quick responses everyone!
Registered User
iTrader: (11)
Joined: Jan 2008
Posts: 6,849
From: Cheesesteakville
Car Info: 05 wrx wagon, 90 celica alltrac, 66 mustang
Thread
Thread Starter
Forum
Replies
Last Post
jasno999
Engine/Power - EJ20T (pre-2006 WRX and JDM)
11
Sep 28, 2004 06:27 AM
jigga
Engine/Power - EJ20T (pre-2006 WRX and JDM)
5
Sep 13, 2004 04:42 PM



