in need of a dyno pull, where should i go?
Thread Starter
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
in need of a dyno pull, where should i go?
ya i am in need of a dyno to find out what is done to my car!
where should i go?
where should i go?
VIP Member
iTrader: (9)
Joined: Nov 2003
Posts: 3,709
From: Walnut Creek, CA
Car Info: CRZ EX-Navi/6MT & Vue Redline
The most likely response on these boards will undoubtedly be GST.
2439 Industrial Parkway West, Suite A
Hayward, CA 94545
Tel: 510.264.9049
Fax: 510.264.9740
2439 Industrial Parkway West, Suite A
Hayward, CA 94545
Tel: 510.264.9049
Fax: 510.264.9740
iClub Silver Vendor
iTrader: (12)
Joined: Mar 2003
Posts: 8,228
From: 631 Railroad Ave. Fairfield, CA
Car Info: A Laptop
You will also be getting trained soon but you know who
To the OP, I'll be happy to look your car over and do a couple logging pulls. This will give you some good info about what's going with the car as well as some plots from my road dyno software.
Thanks
Thread Starter
Registered User
iTrader: (15)
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
ya i think my car has been to yall before......i found some stuff in my car and it has a 3-port boost solenoid, i know yall use to sell those!
16 psi and it ad to have some sort of tune, but i run hella rich
ill check it out!
how much would it cost me?
16 psi and it ad to have some sort of tune, but i run hella rich
ill check it out!
how much would it cost me?
iClub Silver Vendor
iTrader: (12)
Joined: Mar 2003
Posts: 8,228
From: 631 Railroad Ave. Fairfield, CA
Car Info: A Laptop
A lot of people use 3-port solenoids
. PM'd you on the pricing.Thanks
