Hi, looking to change my transmission oil and differential oil at the same time.. on ALLDATA, it says

Manual Transmission Gear Oil Capacity 3.5 Liter (3.7 US qt, 3.1 Imp qt)

Note: Total fluid capacity for the Manual Transmission with front differential and Transfer Case (center differential) is the same capacity for entire unit.

I was confused whether I put 3.7 quarts in the transfer case and I'm done with it? Or do I have to put .8 quarts in the rear diff and the rest in the trans case? Does anyone know the exact fluid capacity for both the transmission and rear diff separately? Any help would be appreciated. Thanks!

 

for the diff, i would just do it until it starts pouring back out.

 

Yeah last time I did it, I did it separately.. I remember putting little less than a quart until it dripped out the top drain plug.. but don't know how much I put for the transmission.. since I put .8 in the rear diff, I put 3 quarts in the transmission? Kinda confused

 

It says here.. http://www.clubwrx.net/forums/genera...-schedule.html

3.7 for the transmission and .8 for the rear diff.. don't want to overfill but ill try it out.

 

rear diff you go until it leaks out. <1 qt
Front tranny / diff has a dipstick. <4 qts

so you start with 5 qts and have left over or you start with 4 qts and don't fill the tranny all the way full.

 

and what did the tranny diptstick say? 3 Qt is well under-filled. Some say the 5MT should be slightly over-filled.

 

Last time I put 3.2 in the trans and .8 or so in the rear diff, I think the transmission was underfilled but the dipstick readings were slightly below normal