i'm about to do the install and was wondering if i need to jack up the car for this... i can get to everything with the car on the ground and me on my back. thanx

 

No jack necessary. I rolled up onto ramps to give me more room, but if you fit them your ok

 

You'll want to do it with your suspension loaded, otherwise it's PITA

 

k, i saw kinda worried about the stock sway bar popping out and killing my baby makers

 

yeah keep the car loaded, don't jack it up and wear goggles because there should be alot of debri under the car

 

as long as you are on a flat surface, the swaybar or endlinks won't be under extreme load.

 

ya i get to install my endlinks today woohoo!

RU-X what kinda sway did you get? and are you doing endlinks too?

 

lol, i got a rear whiteline 24 and yes end links... u?

 

the more level, the better.

 

RU-X i just installed my endlinks not ramp no nothing and it was a bit of a **** in the rain because of being wet lol but they were easy as pie.

a suggestion for the endlinks have a small long bolt so you can tap out the bottom endlink bolt. i had the stocks on and the bolt was kinda stuck in there so i grabbed a bolt to tap it out the rest of the way.

but it wasn't really even a problem.

i got the helix endlinks used shipped 2day ups for $65! so i couldn't pass em up i wanted the whiteline endlinks but oh well.
and i have the stock sway right now i am getting a whiteline rearsway from scoobytuner.com

 

Should have just waited for the sway to come . Would have only had to get under the car once.

 

Haa, that's funny Greg, not rain nor wind or sleet nor hail could keep you from putting on your new endlinks.

 

jeff man i have been dying to get some. and they finally came i HAD to do it.

and sti-owns-evo. i know but i never dread working on my car.

 

lol, that sucks man... u did it on the wet floor? anywho, ur tip came abit late man... LOL i just got back from a test drive... i think its gripping more... i don't know, i didn't wanna push it too hard being in the wet and never driven it before. i put the end links on the bar before i even got it under the car. it was easy, but i did take a long time on the bolt for the mount... **** bolt just didn't wanna go in the hole!!! y didn't subaru make both nuts? i don't know.... but yeah! did it without even taking off the cat/axle back.

 

hidden ****??