click for the open till midnight appointments thread
and let us know so we can stay open. If no appts. we are going home ..

We are doing this because we will be closed on Saturday the 26th of July and will be back on Monday the 28th of July.

cheers

gino,mike and andrew

www.gb-motorsports.com
www.mpjperformance.com

 

I talked to Mike this morning....I need to have you guys check to make sure my motor and tranny mounts are nice and tight....(I got 'em installed saturday) cuz, when I shut off the engine, I can hear a rattle....sounds alot like a loose bolt, just wanna make sure my engine isnt gonna fall out. I will probably come by tomorrow....(Wed) after work between 630-700.

Thanks in advance.

-Ted

P.S. I have some money burning a hole in my pocket...and was thinking about MAYBE getting front/rear sway bars too....

 

bring it in and we can check it out.

 

okay I have 2 appts. for tomorow.

so far so good....

 

I actually need to pick up a utec remote switch from you guys that I ordered way back. I was also wondering about an EGT gauge install into the uppipe bung with an 02 sensor CEL fix and maybe an oil temp gauge install this Thursday evening. How much would it be and how long do you think it would take? Thanks!

John

 

where were you guys today? i tried called the shop a couple times, but no answer. looking to get sti motor mounts and installation.

 

You gotta leave a message when you call them, then they call you right back What time (after 4) is a good time for me to stop by weds or thurs? I picked up the wiring for the height control future horn button, and picked up another horn button for next to the parking break. Also I think my left front bearing or CV joint is on its way out. The metal-on metal noise is getting worse at times, and today in a parking lot I was turning and heard like thunking noises Maybe you could help diagnose the problem? You guys rock

 

Gino,

I should be on tomorrow 2:30pm or so for that rear tower bar that Andrew skipped monday.

And I got your money in cash Friday evening

-Gagan

 

baby mike

just drop by and we can install the mounts.


john

The EGT install on the uppipe bung is eally not the accurate way to go. The no. 3 cylinder is where you need to put that. $80 install charge on just the bung on the correct area (drill and tap into header and we R&R it) and $65 per gauge is what we charge. To save money you can actually install the gauges and leave the wires on the passengerside and we do the plumbing to the engine ($40 charge only) and you do the wiring for power. ($65 we do it it all per gauage) ...Now you n

 

Gagen

thats fine..friday is cool but make it early coz we out on vacation time lol....

 

ted

if the engine tranny bolt is loose it will not vhold when you drive off so better make it back asap. I doubt that that is the problem non the less let us look at it okay.