finally put red tail light overlays on!
Thread Starter
Registered User
Joined: Mar 2010
Posts: 82
From: San Jose, CA
Car Info: '10 SWP STI & '02 GTI 1.8t
finally put red tail light overlays on!
yay! i finally finished. 2.5 hours of nonstop stretching and finger-burning. -.-
however did save myself a good $80 to get them professionally installed..but i think i did an okay job. just need to fix the right one a bit more..
these are the blue batmobile overlays with the cutouts. had to get rid of the clear ricer lights.
where did you guys get yours done?
however did save myself a good $80 to get them professionally installed..but i think i did an okay job. just need to fix the right one a bit more..
these are the blue batmobile overlays with the cutouts. had to get rid of the clear ricer lights.
where did you guys get yours done?
Last edited by vanityb0mb; May 4, 2010 at 12:12 AM.
I have had mine sitting in the garage for months cause Im too scared to put em on. I would like to just get them painted but don't know where to go. Your look good though!
Thread Starter
Registered User
Joined: Mar 2010
Posts: 82
From: San Jose, CA
Car Info: '10 SWP STI & '02 GTI 1.8t
its just those 2 bolts you see when you open up the trunk, remove those then pop it out and unplug the wire.
if you want you can buy a roll of random tint at kragens and practice putting it on. i was gonna do that but i was too excited when it came in so i just wing'd it. hah.
you don't want it to turn out like this

(no offense to whoever's car this is ]: )
It isn't that hard, just take off the tails and take your time. A spray bottle of soapy water + blow dryer will make life easier too.


