i tried to put them on today and one already flew off.if u help me i'll buy someone a case of beer or something.let me know

 

double sided tape and zip ties

 

Are you talking about the front lip splitter or the intercooler splitter?

 

my double sided tape failed on me the zip tie held it on, scrapping against my rim. ohwellz

 

Clean off the area that you stick the double sided tape to with alcohol before applying it. I think there's also a few clips that hold it on at the bottom.. It's really not that hard.

 

Screws on the backside in the fender well, major double stick tape on the inside of the splitter, and use the supplied screws from subaru (If its oem subaru) to hold it down on the bottom. Im in South City if you need help. And its up to you, i cut slits in bumper up at the top of the splitter and jammed the clips on the splitter through the bumper which holds down top of the splitter. ( hard to explain sorry)

 

I really recommend NOT installing it with just double sided tape. I know it works, but it's freaking ghetto. If you're going to install a body part like this, take the time to do it the right way.

Be sure you have the mounting hardware involved. You'll need to make 3 slits on each side for the clips and 3 holes for the snap in brackets. Measure twice, cut once. Put on the splitters and never fear them falling off. It takes more than double the time of double stick, but rest assured, it will never fall off. I also forgot, I think there are 2 more bolts that go on the bottom, or maybe it's 3. But once those are all in, never fear the parts flying off your car.

 

haha my front and rear lip are mounted by double sided tape.

so are my window visors.



but you are the one with the body kit so you might have more experience than me =(

 

industrial double sided tape. So its weatherproof!

Couple zip ties wouldn't hurt either.

 

Onizuka is right, you HAVE to make the slits in the bumper to hold the top of the splitter to the bumper, this is how the top section of the splitter is held in place. If you don't wanna make slices in the bumper... this may not be the mod for you and you may wanna think about a aftermarket bumper

 

you don't have to...

 

but for best fitment, you should. honestly if i could do mine all over again, i would have just went that route of doing it properly. just like everyone says, do it right the first time!