After dyno day results
Originally Posted by dan avoN7
sounds about right. i pulled a few cars on a newer viper from a 40 roll awhile back and that was with 387whp. too bad i needed 100 octane to reach that 
congrats mark! can't wait to hear the new numbers.
congrats mark! can't wait to hear the new numbers.
Originally Posted by ipozestu
Now that's street racing in Danville.
I hear Avons quite the street racer.
Maybe after the cars are done like Rons,Marks(not me),Derricks we can all hit up the track.
2006 Mt Hammy Car Show Winner
iTrader: (11)
Joined: Dec 2002
Posts: 2,730
From: Danville, CA
Car Info: Black 03 WRX, White 04 E46 M3
hah I didn't street race too much, just about 3 cars from when I had my old setup, not like i'm at the runs every weekend with 100's of cars.
By the looks of it my car will never see the track. I went to pick it up last night, then the London Fog set in... He told me about the fuel regulator relocation block from perrin. Apparently they machined the reg. mounting screw hole right into the main return line. Then to top that off the rails have these little plugs that are pressed into the ends of them. Both of them were leaking. WTF is up with QC at Perrin anyhow?. Then the car is up on the lift, and there is fluid leaking out of the axel seal on the tranny. I hope that it was spilled from filling. I wiped it up with hopes it doesn't come back. I HATE MY CAR!!!
I went to pick it up last night, then the London Fog set in... He told me about the fuel regulator relocation block from perrin. Apparently they machined the reg. mounting screw hole right into the main return line. Then to top that off the rails have these little plugs that are pressed into the ends of them. Both of them were leaking. WTF is up with QC at Perrin anyhow?. Then the car is up on the lift, and there is fluid leaking out of the axel seal on the tranny. I hope that it was spilled from filling. I wiped it up with hopes it doesn't come back. I HATE MY CAR!!!
Originally Posted by dan avoN7
hah I didn't street race too much, just about 3 cars from when I had my old setup, not like i'm at the runs every weekend with 100's of cars.
Originally Posted by UK n00b
Stock 04 Viper laid down 384whp an 420ftlbs or so on 91, perhaps gearing or driver came into play.
Mike
Mike
Good to know. Have you ever dyno'd a 911 turbo on the G-S or GST dyno? How bout a C5, C6 Z06 or other 'high powered' cars
Just curious.... would be a nice cocktail fact
Registered User
iTrader: (1)
Joined: Aug 2004
Posts: 372
From: Leaving on a jet plane dont know if i'll be back..
Car Info: 05 STi White v2 8cm FP Red
Originally Posted by STiYLIN
meh, wait until Derek's '05 STi is on there....
Registered User
Joined: Mar 2006
Posts: 418
From: Stop drag racing a rally car, and you'll be OK
Car Info: WRX STi
Originally Posted by blinguskahn
Yeah wait till I return it to stock and buy a Soupragh.
Thread
Thread Starter
Forum
Replies
Last Post
GameOver
Engine Management
16
Jun 13, 2004 02:00 AM
sponaugle
Engine/Power - EJ20T (pre-2006 WRX and JDM)
1
Feb 24, 2003 09:28 AM