Hey I'm adjusting my beam pattern and need to lower it a tad and don't want to fumble around and figure it out. So do any of you guys know for sure which **** is for vertical adjustment? Is it the one highest or lowest one from the top down?

Thanks

 

I think the lower one is up/down, higher one is right/left. And if I recall, turning counterclockwise raises the beam, and vice versa.

On second thought, I could be wrong on everything. Why not just try it out? Its not that hard... You're using a Philips screwdriver and not a hex wrench I hope...

 

correct, the lower one is up/down and higher one is left/right