Suby Shopping & Maintenance/Warranty Buying a Subaru? Buying, negotiating, financing, insurance, etc. Maintenance/Warranty topics can be discussed here too.

Unable to fill gas tank (was: Rear anti-sway bar install issue)

Thread Tools
 
Search this Thread
 
Old Aug 7, 2008 | 12:03 AM
  #1  
blkwagn's Avatar
Thread Starter
Registered User
iTrader: (1)
 
Joined: Apr 2007
Posts: 25
From: NorCal
Car Info: MY02 Wrx Wagon
Unable to fill gas tank (was: Rear anti-sway bar install issue)

I installed a whiteline RSB on my wagon with the stout mounts. When installing it, to tighten the mounts I had to slightly move the fuel pipe. Now when I fill up the car, the auto-shutoff activates when the tank is only about half full. If i start to fill again, it will go for a little bit and then stop again. To get a full tank I have to keep going through this process. When installing the bar it didn't seem like anything got messed up, but something is definately wrong. Can you mess up your fuel pipe?

If anyone has any insight, I would appreciate it.
Old Aug 7, 2008 | 11:22 PM
  #2  
knightsnke's Avatar
Registered User
 
Joined: Dec 2002
Posts: 63
From: Clifton, NJ
Car Info: 2003 WRX
I had a stupid metal pipe in the way also. It was painted black I don't know for sure if its a fuel pipe but it got in the way when I installed my swaybar mounts.
Old Aug 7, 2008 | 11:36 PM
  #3  
wrxisthebest's Avatar
Registered User
iTrader: (15)
 
Joined: Jun 2007
Posts: 9,171
From: Arnold, CA
Car Info: 2003 PSM WRX, 80 Brat ready for Chevy 350 Swap.
i never had anything in the way..
Old Aug 8, 2008 | 10:14 AM
  #4  
GotBoost?'s Avatar
VIP Member
iTrader: (3)
 
Joined: May 2003
Posts: 3,648
From: SBAIC-South BayArea Impreza Club-Campbell, CA-Thur
Car Info: 2003 PSM STi
I had to unbolt my fuel filler tube to install mine. I just opened up the fuel door, took the 3 screws out that hold the fuel spout in place behind the fuel door, and pushed the filler tube out of the way, then after the install, replace the 3 screws holding the filler tube in place, and viola! you're done.

I don't see how you could mess something up doing that install. It's not like you need to actually remove anything related to your fuel filler tube. Are you sure it's not just one of those really sensitive gas pumps that have to be at JUST the right angle or it will shut off like that? I've had a few of those that act like you are describing.
Old Aug 11, 2008 | 08:20 PM
  #5  
blkwagn's Avatar
Thread Starter
Registered User
iTrader: (1)
 
Joined: Apr 2007
Posts: 25
From: NorCal
Car Info: MY02 Wrx Wagon
I have had this issue with multiple gas stations, so I am assuming it is something with my car. I only had the problem with the bolt on the front passenger side of the stout mount. I guess I'll try to get back underneath and make sure everything is in place.
Old Aug 20, 2008 | 06:12 AM
  #6  
Wingless Wonder's Avatar
Registered User
iTrader: (7)
 
Joined: Dec 2002
Posts: 10,029
From: Sacramento CA
Car Info: 02 Impreza WRX sedan
This thread was moved to the Maintenance forum because installation of rear anti-sway bar mounts doesn't directly affect the fuel filler neck or gas tank.

It could be a clogged or bent air vent tube located near the filler neck. If it's partially blocked, the nozzle at the gas pump will shut off prematurely. If it needs replacing, refer to the factory service manuals for your model year.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ecliptic
Suby Shopping & Maintenance/Warranty
12
Jun 17, 2008 12:34 PM
pwn
NorCal Classifieds
10
Aug 11, 2007 06:04 PM
ezombie
Suby Shopping & Maintenance/Warranty
3
Sep 13, 2006 05:29 PM
my3awds
Wanted
0
Apr 11, 2006 04:28 PM




All times are GMT -7. The time now is 12:58 AM.