does anyone have some sort of diagram or pictures of how to gut my cats!

anything would be helpful''

even a detailed description thanks!


p.s. dont post anything about how im not suppose to gut my cats only helping words thanks!

To tell you the truth, it would be much easier if u know how to weld. Our dp are bent, you would either need some kind of special tools that can bend and at the same time act as a dremel. OR you can cut the dp where the cat meets and hammer the **** out of it.

Why not get a ERZ dp? REALLY cheap and no cel thus far with me + im an 06 and i dont have boost creep (before and after tune). I ran tuneless for 4 months.

Is this for your uppipe or downpipe?

dp!

i have a catless up pipe

Which cat?
DP - Just spend the money and get an aftermarket bell mouthed DP. The block plate designs are crap and is just the stock tube running downward at that point. Pointless and too time consuming for it.

Uppipe - possible, just take a mallet and a chisel and whack at it until the guts fall out and is empty.

3rd cat directly after the DP - I did this one over the weekend and was pretty easy. Remove the cat, take a crowbar and keep stabbing the guts through the end of the cat where the donut gasket is and just keep bashing it until chunks come out. You may need to do it at different angles and be sure to remove the 2 metal rings that will fall out as well as this foamy kinda ring inside too. It takes maybe 30min and some agression to get this done. Be patient and just beat the ish out of it :)

ight thanks for the help!

the up pipe is a catless dc!

no problemo :)