alright so i went out and got the tite looking aluminum shifter trim. but i have no idea how to go about installing this thing. im sure many of you out there already have it, or have friends who do. can u please help me out w/ this. thx.

I know there is some trimming that needs to be done to the console to get it to fit.

/\rcanum

Just use duct tape :)

I am pretty sure there is a write of of this at www.wrxyz.com

u gotta dremel a few "notches" to get the trim to fall into place...and i also drilled into the shift boot so the bolts that came with the trim would fit...

http://www.wrxyz.com/forums/attachment.php?s=&postid=17114

in the pic u can see the six spot to drill so the bolts can go through the shift boot...

I used a razor blade to trim the interior edges of the console and a soldering iron to make the notches wher the bolt sleaves. It worked quite well and was not much of a hassel. -if you don't mind the smell of melted plastic. You should probly use a cheap iron too.