DS1 Motorsports
04-08-2006, 05:42 PM
Whats up, I-Club?
We recently joined up as a vendor, but have been around servicing the Chicagoland area since 2004. To celebrate our newfound vendor status, we are tossing up some specials on labor to get some new faces into the shop. We do everything from routine service work all the way up to hardcore racecar fabrication. We are commited to bringing the best in quality and pricing to our customers in a friendly, helpful enviroment. Feel free to PM us with any questions on labor pricing for anything not listed. Buy a part through us? We will deffinatly hook you up on the installlation.
On to the fun part!
Suspension and Brakes
Coilovers $150 :eek:
Springs $200
Front AND rear swaybars and end-links $50
end-links alone $15/set
Four corner pads, rotors, and bleed $150
Transmission
Clutch install $280 :eek:
Engine/Exhaust
Up-pipe $150+gasket cost
Turboback $75
Turbo install $75 :eek:
Like I said, go ahead and give us a shout with any questions. We will occasionaly be open for drop-in work, but schedualing an apointment is the way to go.
Cheers,
Cameron @ DS1
We recently joined up as a vendor, but have been around servicing the Chicagoland area since 2004. To celebrate our newfound vendor status, we are tossing up some specials on labor to get some new faces into the shop. We do everything from routine service work all the way up to hardcore racecar fabrication. We are commited to bringing the best in quality and pricing to our customers in a friendly, helpful enviroment. Feel free to PM us with any questions on labor pricing for anything not listed. Buy a part through us? We will deffinatly hook you up on the installlation.
On to the fun part!
Suspension and Brakes
Coilovers $150 :eek:
Springs $200
Front AND rear swaybars and end-links $50
end-links alone $15/set
Four corner pads, rotors, and bleed $150
Transmission
Clutch install $280 :eek:
Engine/Exhaust
Up-pipe $150+gasket cost
Turboback $75
Turbo install $75 :eek:
Like I said, go ahead and give us a shout with any questions. We will occasionaly be open for drop-in work, but schedualing an apointment is the way to go.
Cheers,
Cameron @ DS1