Coilovers adjust help needed
#1
Registered User
Thread Starter
Join Date: Nov 2016
Location: San Francisco
Posts: 13
Car Info: 2010 sti hatchback
Coilovers adjust help needed
So I got some bc coils couple of week ago
For my hatch so I went ahead and install them
THE way they came two week later I cut my fenders
Put my flares and new wheels and I had to adjust
THE ride height but run in to something weird
In the rear my fender gap are even but coils are not even
IS like 3/4 difference one side is showing 2 1/4 and the other
IS 1 1/4 between spring perch and lower collar
Is there something wrong with them
For my hatch so I went ahead and install them
THE way they came two week later I cut my fenders
Put my flares and new wheels and I had to adjust
THE ride height but run in to something weird
In the rear my fender gap are even but coils are not even
IS like 3/4 difference one side is showing 2 1/4 and the other
IS 1 1/4 between spring perch and lower collar
Is there something wrong with them
#3
Registered User
Thread Starter
Join Date: Nov 2016
Location: San Francisco
Posts: 13
Car Info: 2010 sti hatchback
My bad I was a bit tired last night is almost 1 inch difference
In the showing treads of the coils
I don't think they where like this before cuz I mesure them all the same before the install
And didn't do any adjustment at the time I put them on
After the new wheels and the flares that happened
By the way they're bc coils
In the showing treads of the coils
I don't think they where like this before cuz I mesure them all the same before the install
And didn't do any adjustment at the time I put them on
After the new wheels and the flares that happened
By the way they're bc coils
#5
Registered User
Thread Starter
Join Date: Nov 2016
Location: San Francisco
Posts: 13
Car Info: 2010 sti hatchback
Yeah I check everything line up the same
I was thinking maybe my upper control arm bushing
Are binding causing not to go down all the way
Or there's not enough weight on that side to compress
The spring
I was thinking maybe my upper control arm bushing
Are binding causing not to go down all the way
Or there's not enough weight on that side to compress
The spring
#7
Registered User
Thread Starter
Join Date: Nov 2016
Location: San Francisco
Posts: 13
Car Info: 2010 sti hatchback
Chassis and subframe are flat
Haven't balance the car yet because tha issue
I'm kinda worrie I'm trying to foxy before I go for alignment
And balance
I check prelude on the preload on the spring they're
Same I don't know what to do now
Haven't balance the car yet because tha issue
I'm kinda worrie I'm trying to foxy before I go for alignment
And balance
I check prelude on the preload on the spring they're
Same I don't know what to do now
Thread
Thread Starter
Forum
Replies
Last Post
youie
Suspension, Handling, and Brakes
7
03-19-2003 06:30 AM