STicky AWD

Sold my 04' STi and now cleaning out my garage...

SOLD - Blouch Dominator 1.5xt-r 8mm hot side turbo

SOLD - Borla Hush 3" dual-tip cat back exhaust (flat flange only - no donut adapter)

$140 - Cobb SF intake / airbox / post AFM silicone hose

SOLD - Helix 3" bellmouth high-flow catted downpipe

SOLD - Deatschwerks 850cc sidefeed fuel injectors

SOLD - Grimmspeed air/oil separator

$40 - 4 Continental Extreme Contact DW 225/45-ZR17

$60 - Grimmspeed 3 port electronic boost control solenoid

SOLD - Grimmspeed black turbo heat shield

$40 - CUSCO oil catch can

SOLD - Tactrix Openport 2.0

Other stuff...
Cobb Accessport v1 (loose pin on OBD cable - some broken crystals on LCD)
SOLD - AEM UEGO wideband sensor (sensor only - no gauge)
1/2 case (6 pack) OEM oil filters / crush washers
Snow chains (cables) for STi OE 225/45/-17 and other sizes
SOLD - Fender plug for intake
Grimmspeed intake manifold gasket
OEM STi fuel pump
OEM STi rear sway bar
OEM STi shifter
OEM STi intake air diverter
OEM front splash shield/ rock guard

================================

STicky AWD

updated

weareghosts

Pm'd

my sti 1

iTrader: (15)

STicky AWD

It is rated at 480HP. It only has ~4k miles on it and was run at a pretty conservative 19psi during that time.

You can find out more about the specs here:

https://www.rallysportdirect.com/par...-r-8cm-2-turbo

and here..

Subaru WRX/STi Dominator 1.5XT-R Ball Bearing Turbocharger

drew935

iTrader: (19)

Is there any missing pieces for the Cobb intake or is everything there?

STicky AWD

Everything is there. After reviewing the components on a different website, it looks like I'm missing the front mounting bracket that secures the top front corner of the heat shield cover to the inner fender area as well as the supplied coolant lines.

• cone filter
• intake body
• mounting bracket (for intake body)
• bolt/washer for mounting bracket to intake body
• hose clamp from body to post MAF tube
• hose clamp from body to filter
• Also includes Cobb post MAF tube that is normally sold separately from the Cobb SF kit.
• Heat shield
• Heat shield cover
• heat shield cover to heat shield bolts/washers

The other 2 mounting points use the OE bolts.

jeighty3

Cobb SF intake fits SG forester right? Is it in good condition? I'm Sac area local

STicky AWD

According to rallysportdirect is fits 2002-2007 WRX/STi and 2004-2008 Forester XT.

After looking at that page, I realized I am actually missing a mounting bracket (where the front of the lid mounts to inner fender) and the straight coolant lines that normally come with it.

I apologize for the confusion.